What is IGN signal primary?

The ignition coil primary circuit is turned on and off by the power transistor. This on-off operation induces the proper high voltage in the coil secondary circuit. The malfunction is detected when the ignition signal in the primary circuit is not sent to the PCM during engine cranking or running.

What are the symptoms of a bad condenser?

3 Warning Signs You Have a Bad AC Condenser

  • Loud and abnormal noises coming from the unit.
  • Significantly reduced cooling capability from the unit.
  • The unit is leaking a noticeable amount of fluid past the typical amount of condensation.

Does a ignition condenser need to be grounded?

The condenser body needs to be grounded, and the lead wire can connect anywhere between the coil and points. You can screw the condenser bracket to the coil mounting bracket, and connect the lead wire to the coil primary points wire connector.

Where is the ignition control module located?

On some cars, the ignition module may be housed on or inside the distributor. In other cases, it may be a standalone unit, or it may be integrated into the ignition coil assembly. The ignition module is easy to access and replace on some vehicles, but on others, it’s buried deep inside the engine compartment.

Will an engine run with a bad condenser?

A failing points and condenser system can cause rough running, misfires, lean and rich conditions. If the engine is difficult to start, and runs rough once it does start, then it is time to contact a mechanic to have a look at the system and find out exactly what the problem is.

What does the p1320 code on a Nissan mean?

The power transistor turns on and off the ignition coil primary circuit. This on-off operation induces the proper high voltage in the coil secondary circuit. Need more information on how to fix the P1320 NISSAN code?

What causes the p1320 sensor to be set?

Factors like abnormal electrical resistances in wiring, crankshaft position sensor, ignition coil power transistors, or even the ignition coil itself can cause code P1320 to set, or contribute to its setting, which will cause a warning light to be illuminated. Where is the P1320 sensor located?

How much does it cost to repair a Nissan p1320?

Please try again later. The cost of diagnosing the P1320 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What is the Erra code for Nissan i30?

NOTE: It is very common for code P1320 to be accompanied by codes P0335, P0340, P1335, and/or P1336. If these codes are present, they must be resolved first, and in the above order to avoid a misdiagnosis and the unnecessary replacement of parts and components. I need help with an erra code P1320 on 1999 I30.